When enabled, all 3 templates (Polishing Module, Dressing Tool Pellet, Dressing Tool Cast
Iron) will be generated in a single PDF document with both sides
Choose whether to show each side on separate pages or combine both sides on the same page
for each template
Skip individual sides that are Plano or PO. Templates with mixed sides will only show the non-Plano sides. Note: Automated templates (Lens Holder, Polishing Base) are always excluded from bulk generation.
When enabled, both sides' values will be displayed on the same PDF (Side 2 values below Side
1)
When unchecked, uses default calculations (2.2x diameter, +5 for pellet/cast iron, radius
offsets). Checked: Enables custom formulas to override defaults.
Formula: D = DIA MAX × multiplier
CC parts → CX tools: Part radius + offset, CX parts → CC tools: Part radius - offset
Amount to add to diameter for pellet tooling calculations
H value for pellet mold (stable at 20mm)
Override simple offset with custom mathematical formulas
Leave blank to use default value
Enter the required values for the selected template. These will be used directly in the drawing without calculations.